TM 5-4310-451-14
5-65. BLOWER DRIVE SUPPORT MAINTENANCE
This Task Covers:
a.
Removal
d.
Assembly
b.
Disassembly
e.
Installation
c.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
ì Blower assembly removed (see paragraph 5-63).
ì Grease (Item 22, Appendix E)
ì Blower oil pipe and fitting removed (see paragraph
ì Lubricating oil (Item 28, Appendix E)
5-62).
ì Dry cleaning solvent (Item 38, Appendix E)
ì Marker tags (Item 40, Appendix E)
Tools/Test Equipment:
ì One gasket
ì Two copper washers
ì General mechanics tool kit
ì Seven lockwashers
ì Field automotive shop set
General Safety Instructions:
ì Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area.
ì Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa).
a. REMOVAL
NOTE
Screws are different In size. Tag when removing.
1.
Remove two screws (2 and 3) and copper washers (1). Discard copper washers.
2.
Remove drive support assembly (4) and gasket (5) from rear housing (6). Discard gasket.
TA705109
5-238