TM 5-4310-451-14
5-65. BLOWER DRIVE SUPPORT MAINTENANCE (Cont.)
e. INSTALLATION
1.
Apply a light coat of grease to both sides of new gasket (5).
2.
Install gasket (5) and drive support assembly (4) on rear housing (6).
3.
Install two new copper washers (1) and screws (2 and 3). Torque screws to 25-30 lb.-ft. (34-41 Nìm).
NOTE
If backlash cannot be checked at face of drive gear, check at hub.
4.
Check backlash between drive gear (7) and
camshaft gear (22). Gear backlash should not
exceed 0.010 in. (0.254 mm).
TA705113
FOLLOW-ON TASKS:
ì Install blower oil pipe and fitting (see paragraph 5-62).
ì Install blower assembly (see paragraph 5-63).
5-243
