TM 5-4310-451-14
5-67. GOVERNOR COVER MAINTENANCE (Con’t).
b. DISASSEMBLY
NOTE
Mark lever position on
shaft assembly before
disassembling.
1.
Remove bolt (14), lockwasher (13), lever (12),
and spring (15) from shaft assembly (20).
Discard lockwasher.
2.
Remove retaining ring (16), washer (17), washer
(18), and preformed packing (19) from shaft
assembly (20). Discard preformed packing.
3.
Remove shaft assembly (20) from governor
cover (8).
c. ASSEMBLY
1.
Install shaft assembly (20) in governor cover (8)
and install new preformed packing (19), washer
(18), washer (17), and retaining ring (16).
2.
Install spring (15) and lever (12) on shaft
assembly (20) with new lockwasher (13) and bolt
(14).
d. INSTALLATION
1.
Position new gasket (9) and governor cover (8) on governor housing (10) and install three new lockwashers (1)
and bolts (2).
2.
Install spring retainer (7) in governor cover (8) with new lockwasher (6) and bolt (5).
3.
Aline bracket (11) with hole in governor cover (8) and install new lockwasher (3) and bolt (4).
FOLLOW-ON TASKS:
ì Install load solenoid (see paragraph 5-66).
TA705119
5-249
