TM 5-4310-451-14
5-104.
MINIMUM PRESSURE VALVE REPLACEMENT.
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
• System pressure relieved.
• Adhesive (Item 1, Appendix E)
Tools/Test Equipment:
• Sealing compound (item 14, Appendix E)
• Grease (Item 22, Appendix E)
• General mechanic's tool kit
• Sealant (Item 36, Appendix E)
• Field automotive shop set
• Dry cleaning solvent (Item 38, Appendix E)
• Two nuts (Figure F-9, Appendix F)
• One seal ring
• Two threaded rods (Figure F-9, Appendix F)
• Two gaskets
• Three preformed packings
General Safety Instructions:
• Eight lockwashers
• Dry cleaning solvent Is flammable and must not be
used near open flame. Use only in a well-ventilated
area.
a.
REMOVAL
1.
Remove hose (8) from adapter (9).
2.
Remove four bolts (7) and lockwashers (6) from flange (5) and housing (4). Discard lockwashers.
3.
Remove two capscrews (3) and lockwashers (2) from opposite corners of cover (1). Discard lockwashers.
TA705232
5-384
