hydraulic adapter to it, and squeeze the
b. Dispensing Gear Oil.
control trigger.
(1) Prepare the gear oil pump (4, fig. 10) for
(5) When all the old grease has been forced
operation. Refer to paragraph 53.
out of the bearing, shackle, or other points
(2) Release the reel brake handle from the
being lubricated, release the control
gear oil hose reel (5, fig. 11) and pull out
handle trigger. Disconnect the hydraulic
the proper length of hose. Advance the
adapter from the fitting, and proceed to
meter on the pint meter control valve (13)
the next lubrication point.
to "0".
(6) When all points taking general purpose
Caution
grease have been lubricated, disconnect
Do not try to advance the meter reset
the adapter from the control valve. Wipe
beyond the O-position.
it clean and return it to the accessory
(3) Clean the area around the opening or the
drawer. Rewind the hose on the reel,
filler plug. Remove the cap or plug which
replace the control handle on the bracket.
closes the filler opening. Insert the pint
Latch the reel by moving the handle
meter control valve nozzle (13) into the
downward toward the bottom of the reel.
filler opening. Add oil by squeezing the
control handle trigger until the desired
amount shows on the
1
Tire pressure gage
12
Coupling, hose adapter, 3/8 inch NPT (2 ea)
2
Giant buttonhead whip end hose
13
Pipe caps, 3/8 inch and washers (2 ea)
3
Air chuck
14
Lubrication fittings, 1/4 inch-28 NPT-45 (6 ea)
4
Air line coupler (2 ea)
15
Water adapter
5
Lubrication fittings, 1/8 inch NPT (6 ea)
16
Coupling plugs (2 ea)
6
Lubrication fittings, 3/8 inch NPT (6 ea)
17
Fittings, 3/8 inch NPT (4 ea)
7
Lubrication fittings, 1/4 inch (6 ea)
18
Air blower valve
8
Straight fittings, 1/4 inch (6 ea)
19
Air pressure gage
9
Lubrication fittings, 1/4 inch (2 ea)
20
Hand oil gun
10
Lubrication fittings,1/4 inch 45 28 NPT (6 ea)
21
Hydraulic pressure relief adapter
11
Lubrication fittings, 1/8 inch Hyd Str (6 ea)
22
Hydraulic coupler adapter
Figure 14. Accessory items lower drawer.
27
