Malfunction
Probable
Corrective action
Cause
11. Hose reels do not
a. Loose reel
a. Tighten reel
turn properly.
mounting.
at hub (para 4-34).
b. Defective reel
b. Replace reel
brake,
brake (para 4-34).
c. Other causes.
c. Refer-other
causes to direct and
general support main-
tenance personnel.
Section Ill. ENCLOSURE ASSEMBLY, BATTERY AND ACCESSORY DRAWERS, AND TOOL BOX
lubricant fill tank.
4-5. General
d. Accessory Drawer. The two accessory drawers
a. Enclosure. The lubricating and servicing unit
(fig. 1-1) are mounted on the lubricator right rear
enclosure assembly (fig. 1-1) consists of front and
end, below the hose reels.
rear door assemblies and two identical side doors.
4-6. Enclosure Assembly
Each door consists of two panels with latches for
locking open and two slide locking devices. The en-
a. Removal.
closure is equipped with two hand lifting handles
(1) Remove hose clamp and disconnect the fuel
(fig. 1-2), one at each side corner for removal.
tank filler hose at the filler neck (fig. 1-2).
b. Battery Drawer. The battery drawer (fig. 1-1) is
(2) Disconnect the fuel filler cap chain and static
located at the rear of the lubricator below the hose
wire at the fuel tank filler housing (fig. 1-2).
reels.
(3) Remove four lifting rings (1, fig, 4-1) and
c. Tool Box. The tool box is mounted on the right
ring washers (2) securing the enclosure housing (3)
front part of the lubricator skid, behind the engine
to the unit frame.
Figure 4-1. Enclosure assembly, disassembly and reassembly.
4-4
