TM 55-1905-223-24-8
CHAPTER 2
UNIT MAINTENANCE INSTRUCTIONS
Page
Repair Parts, Special Tools; Test, Measurement, and
Diagnostic Equipment (TMDE); and Support Equipment ......................................
Service Upon Receipt ..........................................................................................
Unit Preventive Maintenance Checks and Services (PMCS)................................
Unit Maintenance Troubleshooting.......................................................................
Unit Maintenance Procedures ..............................................................................
Preparation for Storage or Shipment....................................................................
SECTION I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,
AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified
Table of Organization and Equipment (MTOE) applicable to your organization.
2-2. Special Tools, TMDE, and Support Equipment. Special tools; test, measurement, and diagnostic
equipment; and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools
List (RPSTL), TM 55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC),
Appendix B of this manual.
2-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),
TM 55-1905-223-24P.
SECTION II. SERVICE UPON RECEIPT
2-4. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,
report the damage in accordance with the instructions of DA Pam 738-750.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all
discrepancies in accordance with the instructions of DA Pam 738-750.
c. Check to see whether the equipment has been modified.
d. Remove protective caps, plugs, inserts, wrappings, and tape when inspection/inventory is completed.
Inspect piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.
2-1
