TM 9-4310-397-14
4-35. ENGINE WATER TEMPERATURE GAUGE TESTING AND REPLACEMENT .
This task covers:
a.
Removal
b.
Testing
c.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Kit
Roadside and control panel doors open.
Item 1, Section III, Appendix B
Engine coolant drained. (See para 4-6, e.)
Electrical Repair
Item 3, Section III, Appendix B
a.
Removal.
NOTE
Terminal hardware is supplied with most components and cannot be purchased separately.
Retain all hardware if original component is not being replaced. If component is being replaced,
use new hardware supplied.
(1)
Disconnect temperature connector fitting (Figure 4-31, 1) to engine block.
Figure 4-31. Engine Water Temperature Gauge
(2)
Cut wire tie straps (2) off wire bundles to remove fitting.
(3)
Cut wire tie straps (2), tag (item 18, section II, appendix E), and disconnect wire lead (7) to relay reset
switch.
4-96
