TM 9-4310-397-14
b.
Testing.
(1)
Using a multimeter set to measure resistance, check continuity across terminals.
(2)
If no reading is indicated, replace AMMETER.
c.
Installation.
NOTE
Terminal hardware is supplied with most components and cannot be purchased separately.
Retain all hardware if original component is not being replaced. If component is being replaced,
use new hardware supplied.
(1)
Position AMMETER (5) on front panel and install bracket (4) and secure with two hex nuts (1).
(2)
Use wiring diagram (Figure 4-3) and tags to reinstall wire leads (Figure 4-29, 3) and, two lock washers (2).
(3)
Install two lock washers (2) and hex nuts (1).
(4)
Remove tags from wire leads.
(5)
Connect battery cables to batteries. See paragraph 4-49.
(6)
Close control panel door.
4-93
