TM 9-4310-397-14
4-36. COMPRESSOR OIL TEMPERATURE GAUGE TESTING AND REPLACEMENT.
This task covers:
a.
Removal
b.
Testing
c.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Kit
Roadside and control panel doors are open.
Item 1, Section III, Appendix B
Compressor oil drained. (See para 4-6, d (2).)
Shop Equipment Electrical
Item 3, Section III, Appendix B
a.
Removal.
NOTE
Mounting hardware is supplied with most components and cannot be purchased separately.
Retain all hardware if original component is not being replaced. If component is being replaced,
use new hardware supplied.
(1)
Disconnect COMPRESSOR OIL TEMPERATURE gauge fitting (Figure 4-32, 1).
Figure 4-32. Compressor Oil Temperature Gauge
(2)
Cut wire tie straps (2) and tag (item 18, section II, appendix E) disconnect wire lead (7) to relay reset
switch.
4-98
