TM 9-4310-397-14
4-37. LAMP SWITCH AND LAMP TESTING AND REPLACEMENT . - Continued
NOTE
Mounting hardware is supplied with most components and cannot be purchased separately.
Retain all hardware if original component is not being replaced. If component is being replaced,
use new hardware supplied.
(d)
Remove nut (5), lock washer (6), and flat washer (7) and pull lamp base (8) and lock washer (9) from
front of panel.
c.
Installation.
(1)
Lamps.
(a)
Install lamp base (8) and lock washer (9) thru front of panel.
(b)
Secure lamp base (8) with flat washer (7), lock washer (6) and nut (5).
(c)
Mark wire using marker (10) and install new terminal (4).
(d)
Refer to tags and wiring diagram (Figure 4-3). Connect leads (4).
(e)
Install lamp (3), lamp cover (2) and tighten screw (1).
(2)
Lamp Switch.
(a)
Place nut (Figure 4-33, 7) on switch (3).
(b)
Secure switch (3) and ON/OFF identification plate (6) to panel with lock washer (5) and nut (4).
(c)
Refer to tags and wiring diagram (Figure 4-3). Connect leads (2).
(d)
Connect battery cables to batteries. See paragraph 4-49.
(e)
Close control panel door.
4-102
