TM 9-4310-397-14
4-39. ENGINE OIL PRESSUREF GAUGE TESTING AND REPLACEMENT .
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Kit
Roadside and control panel doors open.
Item 1, Section III, Appendix B
Shop Equipment Electrical
Item 3, Section III, Appendix B
a.
Removal.
NOTE
Mounting hardware is supplied with most components and cannot be purchased separately.
Retain all hardware if original component is not being replaced. If component is being replaced,
use new hardware supplied.
(1)
Disconnect hose (Figure 4-36, 1), male connector (2), bushing reducer (3), and pipe coupling (4).
Figure 4-36. Engine Oil Pressure Gauge
(2)
Remove two each hex nuts (5), lock washers (6), bracket (7), and remove ENGINE OIL PRESSURE
gauge (8).
4-105
