TM 9-4310-397-14
4-38. TACHOMETER TESTING AND REPLACEMENT . - Continued
(3)
Remove two each mounting nut (4) and lock washer (5) and remove mounting bracket (6) and tachometer
(7).
b.
Installation.
NOTE
Terminal and mounting hardware are supplied with most components and cannot be purchased
separately. Retain all hardware if original component is not being replaced. If component is being
replaced, use new hardware supplied.
(1)
Place tachometer (7) through control panel and secure with bracket (6) and two each nuts (4) and lock
washers (5).
(2)
See tags and wiring diagram (Figure 4-3) and secure wire leads (1) with four lock washers (3) and nuts (2).
(3)
Connect battery cables to batteries. See paragraph 4-49.
(4)
Close control panel door.
4-104
