TM 3-1040-263-34
b. Installation. Installation is the reverse of
(9) Assemble
canvas
group
(TM
3-
removal (a above). Tighten bolts (28) (10 to 12 pound-
1040263-12).
feet).
4-53.
Engine Adapter
4-56.
Fuel Line
a.
Removal.
a. Manufacture. Fabricate fuel line (5, fig. 4-
(1) Remove canvas group (TM 3-1040-
18) according to figure P19.
26312).
b. Removal and Installation. Direct support
(2) Remove protecting cage (para 3-7).
maintenance personnel are authorized to remove the
damaged fuel line and replace it.
(3) Remove the compressor (para 4-32).
4-57.
Left and Right-Hand Brackets
(4) Remove four bolts (20, fig. 4-18) and
lockwashers (19).
NOTE
(5) Remove engine adapter (21).
The removal of the left and right-hand brackets
is identical. The instructions to remove and
b. Installation.
Installation is the reverse of
install one is described below.
removal (a above).
a.
Removal.
4-54.
Exhaust Pipe
(1) Remove canvas group (TM 3-1040-
a.
Removal.
26312).
(1) Remove canvas group (TM 3-1040-
(2) Remove two cap screws (8, fig. 4-18)
26312).
and lockwashers (9).
(2) Remove protective cage (para 3--7).
(3) Remove and discard three self-locking
(3) Remove two nuts (24, fig. 4-18),
bolts (30).
lockwashers (25), and screws (26).
(4) Remove left-hand bracket (31).
(4) Remove exhaust pipe (27).
b. Installation. Installation is the reverse of
b. Installation.
Installation is the reverse of
removal (a above) except for the following procedure:
removal (a above).
Torque new bolts (30 and 32) (5 to 7 pound-feet).
4-55.
Pulley
4-58.
Fuel Tank Clamps
a.
Removal.
a. Manufacture. Fabricate fuel tank clamps
(30, fig. 3-2) according to figure 4-20.
(1) Remove canvas group (TM 3-1040-
26312).
b. Removal and Installation. Direct support
maintenance personnel are authorized to remove a
(2) Remove two starter flange bolts (28,
damaged tank clamp and replace it.
fig. 4-18) securing pulley (29) to the engine (34).
(3) Remove the pulley (29) from the
engine.
4-34