TM 3-1040-263-34
(3) Remove fuel line and fuel tank (para 3-
(2) Insert four rivets (32) into alined holes,
9).
and secure nameplate (33) by peening rivets.
(4) Remove cap screws (8, fig. 4-18) and
4-62.
Mounts
lockwashers (9) securing engine and compressor
assembly to engine mounting frame (38, fig. 3-2).
Four rubber mounts are located at each bottom corner of
the engine mounting frame.
(5) Remove engine and compressor
assembly from engine mounting frame (38).
Removal.
a.
(6) Remove compressor nameplate (para
(1) Remove locknut (34), washer (35), and
screw (36).
(7) Remove mounts (para 4-62).
B
Cleaning and Inspection.
(2) Remove mount (37) from engine mounting
frame (38).
(1) Wipe engine mounting frame (38) with
a clean, dry, cloth.
Installation.
b.
(2) Remove oil or grease with drycleaning
(1)Position mount (37) to bottom corner of
solvent.
engine mounting frame (38). Aline hole.
(3) Inspect engine mounting frame for
(2) Insert screw (36) and secure with
distortion, cracks, and defective painted areas.
washer (35) and nut (34).
Repair.
c.
4-63.
Protecting Cage
(1) Straighten frame tubing.
General support maintenance personnel are authorized
to straighten or weld (TM 9-237) aluminum tubing of the
(2) Weld cracks (TM 9-237).
protecting cage.
(3) Prime and paint defective paint areas,
4-64.
Engine Mounting Frame
using Enamel, semigloss, rust-inhibiting, TT-E-485.
a. Removal.
d. Installation.
Installation is the reverse of
removal (a above).
(1) Remove water separator (para 3-2).
(2) Remove protecting cage (para 3-7).
4-37