TM 5-4310-227-15
3-61. Engine
line (para 3-34), and drain plug and
a. Removal.
fittings (para 3-65).
(1) Remove the belt set (para 3-59).
(2) Remove the four nuts (1, fig. 3-21),
lockwashers (3), and capscrews (2)
that secure the cylinder and crankcase
a. Removal.
assembly to the mounting base (4).
(1) Remove the belt set (para 3-59).
Lift the engine from the mounting
(2) Loosen the coupling nut (2, fig. 3-
base.
(3) For models B M W - 4 5 2 - E N G a n d
(1) to the aftercooler manifold (3).
BMW-452-ENG-1
remove
also
(3) Remove the four bolts (4), flat wash-
ground cable (10, fig. 3-17), gov-
ers, lockwashers, and nuts (5) that
ernor control cable, choke lever cable,
secure the compressor assembly (6)
tag and disconnect electrical cables
to the mounting base (7) and lift off
and wires, remove fuel line (para 3-
the compressor assembly.
tings (para 3-65).
b. Installation.
b. Installation.
(1) Position the compressor assembly (6)
on the mounting base (7) and secure
(1) Position the cylinder and crankcase
with the four bolts (4), flat washers,
assembly on the mounting base (4)
lockwashers, and nuts (5).
and install the four capscrews (2),
(2) T i g h t e n the coupling nut (2) that
lockwashers (3), and nuts (1).
and
(2) F o r models BMW-452-ENG
secures the after-cooler tube (1) to
the aftercooler manifold (3).
BMW-452-ENG-1 also install strap
(3) Install and adjust the belt set (para
(10, fig. 3-17), governor control ca-
ble and choke control cable (para 3-
