TM 5-4310-276-14
(2) Install cover (8) with washer (6) and screw
(7).
Drycleaning solvent, P-D-680, used to
(3) Install bracket (12) with washers (10,11),
clean parts is potential] y dangerous to
and screw (9).
personnel and property. Avoid re-
(4) Install adapter (5).
peated and prolonged skin contact.
(5) Install bearing cup (2) and shims (l).
Do not use near open flame or exces-
sive heat.
mounting nuts to 100-125 inch-pounds.
(1) Clean all parts with drycleaning solvent,
item 5, App. D.
NOTE
(2) Inspect the bearing cap for cracks, breaks,
When installing the bearing cap assembly, attain
stripped or damaged threads, elongated mounting
the proper crankshaft end-play by utilizing shims
holes or other damage.
(0.000 -0.003 in,) (0.000 -0.007 cm).
(3) Inspect bearing cup for wear, pitting, sco-
ring and evidence of overheating.
(7) Install key on crankshaft and then place
(4) Inspect shims for damage.
magnet on crankshaft.
(5) Replace or repair any damage or defective
(8) Install cable and grommet and connect low
part.
tension cable lead.
c. Reassembly and Installation.
(9) Install capacitor.
(1) Install new oil seal (3) in bearing cap (4),
(10) Install coil and clamps.
(11) Connect coil leads. -
(12) Install flywheel-fan assembly.
CAMSHAFT
AND
VALVE
TAPPETS
Section VIII.
6-18. General
cylinder head assembly.
The camshaft operates the pushrod lifters and
drives the governor assembly and fuel pump.
tainer and remove the oil pan in accordance with
6-19. Camshaft and Valve Tappets
a. Removal and Disassembly.
ring (6).
