TM 5-4310-350-14
b. Inspection.
(2) Use a rag which has been dampened
with cleaning solvent, PD-680, to remove all
(1) Inspect the receiver for excessive ac-
oil spots, then dry thoroughly, to avoid further
cumulation of dust, and leaking or spilled oil.
accumulation.
(2) Check air lines and the service line
for leaks. Tighten loose connections.
d. Draining Condensate from Receiver.
c. Cleaning.
(1) Turn ON-OFF Switch to OFF.
(1) Use compressed air to blow dust off the
(2) Open draincock at bottom of the air
receiver.
receiver tank (fig. 11) under the service line.
(3) When the air has escaped, leave drain-
WARNING
cock open for a few minutes to allow more of
condensate to escape.
Dry cleaning solvent P-D-680, aused to
(4) Close draincock.
clean parts is potentially dangerous to
(5) Be sure that all rags, tools, etc. have
personnel and property. Avoid repeated
been removed from the air receiver, then move
and prolonged skin eontact. Do not use
the ON-OFF switch to ON.
near open flame or excessive heat Flash
point of solvent is 100 F. -- 138 F
(38 C. -- 59 C.).