TM 5-4310-354-14
B RECEIVER PRESSURE GAUGE
REMOVAL
STEP 1.
DISCONNECT AIR PRESSURE HOSE
FROM CONNECTOR.
DISCONNECT
WIRE ASSEMBLIES FROM PRESSURE
TS5-4310-354-14/4-34 (2)
SWITCH.
REINSTALL SCREWS IN
PRESSURE SWITCH TERMINALS TO
PREVENT THEIR LOSS.
C COMPRESSOR OIL TEMPERATURE GAUGE
STEP 2.
UNSCREW
AND
REMOVE
THE
REMOVAL
PRESSURE
SWITCH,
REDUCING
BUSHING, HOSE CONNECTOR, AND TEE
FROM GAUGE.
STEP 1.
REMOVE
COMPRESSOR
OIL
TEMPERATURE SENSING BULB FROM
STEP 3.
REMOVE
NUTS,
LOCK
WASHERS,
COMPRESSOR DISCHARGE ELBOW.
MOUNTING
BRACKET;
REMOVE
RECEIVER PRESSURE GAUGE FROM
STEP 2.
REMOVE NUTS, LOCK WASHERS, AND
INSTRUMENT PANEL.
MOUNTING
BRACKET.
REMOVE
COMPRESSOR
OIL
TEMPERATURE
INSTALLATION
GAUGE FROM INSTRUMENT PANEL.
STEP 1.
POSITION
RECEIVER
PRESSURE
GAUGE ON INSTRUMENT PANEL AND
INSTALLATION
SECURE WITH MOUNTING BRACKET,
LOCK WASHERS, AND NUTS.
STEP 1.
INSTALL
COMPRESSOR
OIL
TEMPERATURE
GAUGE
ON
STEP 2.
INSTALL TEE ON GAUGE WITH BRANCH
FACING UPWARD, INSTALL REDUCING
INSTRUMENT PANEL.
SECURE WITH
BUSHING AND PRESSURE SWITCH IN
MOUNTING BRACKET, LOCK WASHERS,
BRANCH. INSTALL HOSE CONNECTOR
AND NUTS.
IN RUN OF TEE.
STEP 2.
INSTALL
COMPRESSOR
OIL
STEP 3.
CONNECT
WIRE
ASSEMBLIES
TO
TEMPERATURE SENSING BULB IN
PRESSURE SWITCH TERMINALS (REFER
TO
WIRING
DIAGRAM,
COMPRESSOR DISCHARGE ELBOW.
CONNECT AIR PRESSURE HOSE TO
CONNECTOR IN TEE.
Figure 4-34. Instrument panel controls, instruments, and gauges, removal and installation (sheet 2 of 7).
4-67
