TM 5-4310-354-14
F
ENGINE FUEL PRESSURE GAUGE
REMOVAL
STEP 1.
DISCONNECT FUEL PRESSURE HOSE
FROM
CONNECTOR
ON
GAUGE.
REMOVE THE CONNECTOR.
STEP 2.
REMOVE NUTS, LOCK WASHERS, AND
TS5-4310-354-14/4-34 (4)
MOUNTING BRACKETS. REMOVE FUEL
PRESSURE GAUGE FROM INSTRUMENT
G
QUICK-START CONTROL CABLE
PANEL.
REMOVAL
INSTALLATION
STEP 1.
DISCONNECT QUICK-START CONTROL
STEP 1.
INSTALL FUEL PRESSURE GAUGE ON
CABLE
FROM
ACTUATING
VALVE
INSTRUMENT PANEL AND SECURE WITH
LEVER. LOOSEN CABLE CLAMP AND
MOUNTING
BRACKETS,
LOCK
REMOVE CABLE FROM CLAMP.
WASHERS, AND NUTS.
STEP 2.
UNSCREW NUT SECURING HANDLE TO
STEP 2.
INSTALL
FUEL
PRESSURE
HOSE
INSTRUMENT PANEL. REMOVE HANDLE
CONNECTOR ON GAUGE AND CONNECT
AND CABLE FROM INSTRUMENT PANEL.
THE FUEL PRESSURE HOSE.
REMOVE NUT AND WASHER.
INSTALLATION
STEP 1.
INSTALL HANDLE ON INSTRUMENT
PANEL BY RUNNING CABLE THROUGH
HOLE
IN
PANEL
AND
THROUGH
WASHER
AND
MOUNTING
NUT.
SECURE HANDLE TO PANEL WITH NUT.
STEP 2.
INSTALL CABLE THROUGH
CABLE
CLAMP
ON
ACTUATING
VALVE
ASSEMBLY. TIGHTEN CABLE
CLAMP,
AND CONNECT ACTUATING WI
RE TO
VALVE ASSEMBLY LEVER.
Figure 4-34. Instrument panel controls, instruments, and gauges, removal and installation (sheet 4 of 7).
4-71
