TM 5-4310-354-14
WIRE ASSEMBLIES TO OIL PRESSURE
SWITCH TERMINALS AND TO IGNITION
SWITCH TERMINAL. (REFER TO FIG 1-3.)
STEP 3.
INSTALL START PUSHBUTTON SWITCH
ON INSTRUMENT PANEL AND SECURE
WITH KNURLED MOUNTING NUT.
STEP 4.
CONNECT WIRING HARNESS LEAD AND
WIRE ASSEMBLY TO START SWITCH.
(REFER TO FIG 1-3.)
H
START PUSHBUTTON AND SAFETY
OVERRIDE PUSHBUTTON SWITCHES
REMOVAL
STEP 1.
DISCONNECT WIRE ASSEMBLY AND
WIRING HARNESS LEAD FROM START
SWITCH.
STEP 2.
REMOVE KNURLED MOUNTING NUT
FROM FRONT OF INSTRUMENT PANEL
AND REMOVE THE START PUSHBUTTON
SWITCH.
STEP 3.
DISCONNECT
SAFETY
OVERRIDE
PUSHBUTTON
SWITCH
WI
RE
ASSEMBLIES FROM IGNITION SWITCH
TS5-4310-354-14/4-34 (5)
AND
BOTH
TERMINALS
OF
OIL
PRESSURE SWITCH.
I
IGNITION ON-OFF SWITCH
STEP 4.
REMOVE KNURLED MOUNTING NUT
REMOVAL
FROM FRONT OF INSTRUMENT PANEL
STEP 1.
DISCONNECT WI RING HARNESS LEAD
AND
REMOVE
SAFETY
OVERRIDE
AND WIRE ASSEMBLIES FROM IGNITION
PUSHBUTTON SWITCH, WITH WIRE
ON-OFF SWITCH TERMINALS.
ASSEMBLIES
ATTACHED.
AS
NECESSARY,
REMOVE
THE
WIRE
STEP 2.
REMOVE MOUNTING NUT FROM FRONT
ASSEMBLIES.
OF INSTRUMENT PANEL AND REMOVE
THE IGNITION ON-OFF SWITCH.
INSTALLATION
INSTALLATION
STEP 1.
AS
NECESSARY,
CONNECT
WIRE
ASSEMBLIES TO SAFETY OVERRIDE
STEP 1.
INSTALL IGNITION ON-OFF SWITCH ON
PUSHBUTTON
SWITCH
BEFORE
INSTRUMENT PANEL AND SECURE WITH
INSTALLING SWITCH ON INSTRUMENT
MOUNTING NUT.
PANEL. (REFER TO WIRING DIAGRAM,
STEP 2.
CONNECT WIRE ASSEMBLIES AND
WIRING HARNESS LEAD TO SWITCH
STEP 2.
INSTALL SAFETY OVERRIDE SWITCH ON
TERMINALS.
(REFER TO WIRING
INSTRUMENT PANEL AND SECURE WITH
DIAGRAM, FIG 1-3.)
KNURLED MOUNTING NUT. CONNECT
Figure 4-34. Instrument panel controls, instruments, and gauges, removal and installation (sheet 5 of 7).
4-73
