TM 5-4310-354-14
REMOVAL
STEP 1. DISCONNECT WIRING HARNESS LEADS
AND
WIRE
ASSEMBLIES
FROM
AMMETER TERMINALS. REASSEMBLE
TERMINAL WASHERS AND NUTS TO
PREVENT THEIR LOSS.
STEP 2. REMOVE NUTS, LOCK WASHERS, AND
MOUNTING
BRACKET.
REMOVE
AMMETER FROM INSTRUMENT PANEL.
INSTALLATION
STEP 1. INSTALL AMMETER ON INSTRUMENT
PANEL.
SECURE WITH MOUNTING
BRACKET, LOCK WASHERS, AND NUTS.
STEP 2. CONNECT WI RE ASSEMBLIES AND WI
RING HARNESS LEADS TO AMMETER
K
ENGINE WATER TEMPERATURE GAUGE
TERMINALS.
(REFER TO WIRING
DIAGRAM, FIG 1-3).
REMOVAL
STEP 1.
UNSCREW
AND
REMOVE
ENGINE
WATER TEMPERATURE SENSING BULB
FROM CYLINDER HEAD.
STEP 2.
REMOVE NUTS, LOCK WASHERS, AND
MOUNTING BRACKET. REMOVE ENGINE
WATER TEMPERATURE GAUGE FROM
INSTRUMENT PANEL.
TS5-4310-354-14/4-34 (7)
INSTALLATION
STEP 1.
INSTALL ENGINE WATER TEMPERATURE
M
TACHOMETER-HOURMETER
GAUGE
ON
INSTRUMENT
PANEL.
SECURE WITH MOUNTING BRACKET,
REMOVAL
LOCK WASHERS, AND NUTS.
STEP 1.
DISCONNECT
TACHOMETER
DRIVE
STEP 2.
INSTALL ENGINE WATER TEMPERATURE
CABLE. REMOVE TACHOMETER DRIVE
SENSING BULB IN CYLINDER HEAD.
ADAPTER.
STEP 2.
REMOVE NUTS, LOCK WASHERS, AND
MOUNTING BRACKET.
REMOVE THE
TACHOMETER-HOURMETER
FROM
INSTRUMENT PANEL.
INSTALLATION
STEP 1.
INSTALL
TACHOMETER-HOURMETER
ON INSTRUMENT PANEL.
SECURE
WITH MOUNTING BRACKET, LOCK
WASHERS, AND NUTS.
STEP 2.
INSTALL TACHOMETER DRIVE ADAPTER
AND CONNECT DRIVE CABLE.
L
AMMETER GAUGE
Figure 4-34. Instrument panel controls, instruments, and gauges, removal and installation (sheet 7 of 7).
4-77
