TM 5-4310-354-14
b. Cleaning and Inspection.
4-63. Control Cables.
a. Removal. Remove the idle control cable and/or
(1) Clean the control cables with solvent,
the compressor unloader control cable as shown in J,
Federal Specification P-D-680, Type II.
Dry thoroughly.
(2) Inspect cables for breaks, kinks, or any
WARNING
other defect.
Dry cleaning solvent, P-D-680, used
(3) Inspect attaching parts for distortion,
to
clean
parts
is
potentially
damaged threads, or any other defect.
dangerous
to
personnel
and
property.
Avoid repeated and
c. Installation. Install the idle control cable and/or
prolonged skin contact. Do not use
compressor unloader control cable as shown in J, figure 4-34.
near open flame or excessive heat.
Flash point of solvent is 100 F-130 F
(38 C-59 C).
4-74
