TM 5-4310-354-14
TS5-4310-354-14/7-10
1.
Screw and lock washer
12.
Drive housing bushing
22.Retainer
32.Lock washer (4)
2.
Screw (2)
13.
Nut
23.Clutch and drive assy
33.Screw (4)
3.
Lock washer (2)
14.
Lock washer
24.Ground brush screw (2)
34.Brush holder support (2)
4.
Solenoid switch
15.
Lever stud
25.Insulating brush screw (2)
35.Ground lead (2)
5.
Plunger spring
16.
Shift lever
26.Brush (4)
36.Support package (2)
6.
Lever pin
17.
Dowel pin
27.Brush holder pin (2)
37.Pole shoe screw (4)
7.
Plunger
18.
Washer
28.Ground brush holder (2)
38.Pole shoe (4)
8.
Through bolt (2)
19.
Armature
29.Insulating brush holder
39.Grommet
9.
Commutator end frame
20.
Thrust collar
(2)
40.Field coil assembly
10.
Frame bushing
21.
Retaining ring
30.Brush spring (2)
41.Frame
11.
Driving housing
31.Nut (4)
Figure 7-10. Starting motor assembly, disassembly and reassembly.
(1) Remove screw and lock washer (1), two screws
(5) To remove retaining ring (21), retainer (22), and
(2), two lock washers (3), and solenoid switch
the clutch and drive assembly (23), slide a metal
(4). Remove the plunger spring (5), lever pin
cylinder onto shaft, strike the cylinder with a
(6), and plunger (7).
hammer driving the retainer toward the armature
core and off the retaining ring as shown in
(2) Remove the two through bolts (8). Remove
commutator end frame (9). Do not remove
groove in the armature shaft, remove the
frame bushing (10) unless replacement is
retainer and clutch and drive assembly.
necessary. Remove drive housing (11) from
starter frame (41). Do not remove drive housing
NOTE
bushing (12) unless replacement is necessary.
The clutch and drive assembly is
(3) Disassemble nut (13), lock washer (14), lever
serviced as an assembly. Do not
stud (15), and shift lever (16) from housing (11).
attempt to disassemble.
Remove dowel pin (17) only as necessary.
(4) Remove washer (18) from armature (19)
shaft and remove the armature (19).
Remove
thrust collar (20).
7-10
