TM 5-4310-368-14
a.
Removal
(1)
Disconnect wire between magneto and temperature switch at the temperature switch.
(2)
Remove one cylinder head bolt and temperature switch.
b.
Inspection and Testing
(1)
Inspect temperature switch for cracks, loose wire terminal and signs of damage.
Use multimeter to check temperature switch for continuity. Switch should be closed below 195 .
(2)
F
(3)
Replace defective switch.
(4)
Inspect cylinder head bolt for damaged threads. Replace defective bolt.
c.
Installation
(1)
Slide temperature switch onto cylinder head bolt.
(2)
Assemble cylinder head bolt and temperature switch into cylinder head. Tighten to 24 Ib-ft torque.
(3)
Connect wire from magneto to temperature switch.
4-31.
INTAKE AND EXHAUST MANIFOLD
This task covers:
a.
Removal
b.
Cleaning and Inspection
c.
Installation
INITIAL SETUP
Applicable Configurations
All
4-30
