TM 5-4310-368-14
4-26.
MAGNETO
This task covers:
a.
Inspection
c.
Repair and Overhaul
b.
Removal
d.
Installation
INITIAL SETUP
Applicable Configurations
All
Equipment Condition
Paragraph
Condition Description
Front Enclosure Panel Removed
Alternator Belt Removed
Flywheel Screen Removed
a.
Inspection
(1)
Remove one spark plug wire and hold about 1/4 inch from block. Crank engine over and watch for
spark. If no spark appears, repair or replace magneto.
b.
Removal
(1)
Disconnect four spark plug wires.
(2)
Disconnect ground strap.
(3)
Disconnect main wire harness at one place.
(4)
Remove nut.
(5)
Remove bolt and lock washers and nut.
(6)
Remove magneto.
c.
Repair and Overhaul. Refer to direct support maintenance.
4-25
