TM 5-4310-368-14
Equipment Condition
Paragraph
Condition Description
Carburetor Removed
Exhaust Pipe Removed
General Safety Precautions
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel
and property. Avoid repeated and prolonged skin contact. Do not use near open flame
or excessive heat. Flash point of solvent is 100 (38 ) - 138 (59 ).
F
C
F
C
a.
Removal
(1)
Remove carburetor. Refer to direct support maintenance.
(2)
Remove two bolts, two nuts and four washers. Remove seal clamp.
(3)
(4)
Remove four nuts and four washers.
(5)
Remove intake and exhaust manifold assembly.
b.
Cleaning and Inspection
(1)
Clean all parts in cleaning solvent. Dry thoroughly.
(2)
Inspect all threaded parts and tapped holes for thread damage. Repair or replace defective
components.
(3)
Inspect sealing surfaces for damage. Repair damaged surfaces.
(4)
Inspect castings for cracks, breaks and leakage. Replace defective castings.
c.
Installation
(1)
Install four new manifold seals into cylinder block.
(2)
Position intake and exhaust manifold assembly over studs in cylinder block.
4-31
