TM 5-4310-368-14
b. Installation
(1)
Position axle assembly under compressor.
(2)
Align bolt holes in axle pods with bolt holes in frame.
(3)
Install and secure four bolts and washers.
(4)
Install brake rods at axle. Secure with cotter pins.
5-5.
FUEL TANK
a. Removal
(1)
Remove axle (paragraph 5-4). (Figure 5-14)
(2)
Drain fuel.
(3)
Disconnect two fuel lines at top of tank.
(4)
Disconnect wire at fuel level sensor.
(5)
Remove eight bolts and eight washers.
(6)
Remove tank.
b. Installation
(1)
Position fuel tank under frame. Raise tank up to the underside of the frame.
(2)
Align the eight bolt holes in the fuel tank with the eight bolt holes in the frame.
(3)
Secure the tank to the frame with eight bolts and eight nuts.
(4)
Attach wire assembly at fuel level sensor.
(5)
Attach and secure two fuel lines at top of tank.
(6)
Install axle assembly (paragraph 5-4). (Figure 5-14)
(7)
Fill tank with fuel. Verify operation of fuel gage.
(8)
Start engine and check for fuel leaks. Repair any leaks.
(9)
Stop engine.
5-10
