TM 5-4310-378-14
(24)
With the rope (3) hooked into the reel (5) notch, obtain spring tension by turning the
reel four revolutions counterclockwise.
Remove rope (3) from notch in reel (5) pulley and let reel slowly turn clockwise as
(25)
rope winds onto reel and handle returns to guide bushing on housing (12).
(26)
Install compression spring (1O).
(27)
Install return spring (7) with bent end hooked into hole of reel (5) hub and looped end
toward the outside.
(28)
Install ratchets (11) so they fit the contour of the recesses in the reel (5) hub (tips
pointed in a counterclockwise direction).
(29)
Install ratchet retainer (4) so that loop end of return spring (7) extends through slot.
Rotate ratchet retainer (4) slightly clockwise until the two small slots in the
(30)
retainer just begin to engage the two ratchets (11).
Press down on ratchet retainer (4) and install thrust washer (9) and clip (8).
(31)
3-35. CYLINDER HEAD AND GASKET
This task covers:
Service
Materials:
Equipment Condition:
a. Service.
(1)
Remove dirt from between
cooling fins.
Check cylinder head (2) for
(2)
distortion. If head is warped,
notify supervisor.
3-55