TM 5-4310-451-14
4-72. TIE-ROD MAINTENANCE (Con’t).
b.
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective goggles and
gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO
NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s flash point is
1000F-1380F (380C-590C). If you become dizzy while using cleaning solvent, immediately get
fresh air and medical help. If solvent contacts eyes, immediately wash your eyes and get medical
aid.
1.
Clean tie-rod with dry cleaning solvent. Allow to dry.
2.
Inspect tie-rod for bends and cracks or signs of looseness. Replace tie-rod if bent, broken, or loose.
3.
Inspect two lubrication fittings (10) in tie-rod (8)
for damage. Remove and discard lubrication
fittings If damaged.
c.
INSTALLATION
1.
If removed, install two lubrication fittings (10) in
tie-rod (8).
2.
Position tie-rod (8) on steering knuckle (4) and steering arm (1).
3.
Install nut (5) and new cotter pin (6) on tie-rod end (7).
4.
Install nut (2) and new cotter pin (3) on tie-rod end (9).
TA704832
4-176
