TM 5-4310-451-14
5-34. FLYWHEEL HOUSING AND REAR OIL SEAL REPLACEMENT (Con’t).
18.
Install four aligning studs (49), part of alignment stud set, through flywheel housing (4) into engine block (48).
WARNING
Use extreme caution when handling heavy parts. Lifting device Is required when parts weigh over
50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg)
for a three or more person lift. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause serious Injury or death to personnel.
NOTE
Gasket may stick to flywheel housing
or rear end plate.
19.
Remove flywheel housing (4) from rear end plate
(51).
20.
Remove gasket (50) from flywheel housing (4) or
rear end plate (51).
21.
If damaged, remove pipe plugs (52 and 53) from
flywheel housing (4).
22.
Remove four aligning studs (49) from engine
block (48).
23.
Remove oil seal (54) from flywheel housing (4).
Discard oil seal.
5-96
