TM 5-4310-451-14
5-34. FLYWHEEL HOUSING AND REAR OIL SEAL REPLACEMENT (Con’t).
24.
Remove four screws (1), washers (2), and two
engine lifting brackets (3) from flywheel housing
(4), if replacing flywheel housing.
b. INSTALLATION
1.
If removed, install two engine lifting brackets (3)
on flywheel housing (4) with four washers (2)
and screws (1).
2.
Install new oil seal (54), numbered side up, in flywheel housing (4).
3.
Apply grease to flywheel housing (4) and install new gasket (50).
4.
Apply grease on gasket (50).
5.
If removed, apply adhesive to threads of pipe plugs (52 and 53) and install In flywheel housing (4).
6.
Apply light coat of lubricating oil to inside diameter of oil seal (54).
7.
Install four aligning studs (49) in engine block (48).
WARNING
Use extreme caution when handling heavy parts. Lifting device Is required when parts weigh over
50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg)
for a three or more person lift. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause serious Injury or death to personnel.
8.
Install flywheel housing (4) and gasket (50) on rear end plate (51) and engine block (48).
TA704977
5-97
