TM 9-4310-397-144-32. INSTRUMENTCONTROLPANELWIRINGHARNESSTESTING.REPAIRANDREPLACEMENT .This task covers: a.Removalb.Testingc.Disassemblyd.Repaire.Assemblyf.InstallationINITIAL SETUPTools:EquipmentConditions:General Mechanics Tool KitBattery cables disconnected from batteries.Item 1, Section III, Appendix B(See para 4-49.)Electrical RepairItem 3, Section III, Appendix Ba.Removal.(1)Wiring Harness.(a)Cut tie down electrical wraps (Figure 4-28, 1) and (2).NOTETerminal hardware is supplied with most components and cannot be purchased separately.Retain all hardware if original component is not being replaced. If component is being replaced,use new hardware supplied.(b)Tag (item 18, section II, appendix E) leads.(c)Remove terminal attaching hardware on individual components to remove terminal lug connections.(d)Reinstall terminal attaching hardware back on components to prevent loss.(e)Carefully remove harness (3) from air compressor.(2)WireLeads.(a)Tag (item 18, section II, appendix E) leads (4).(b)Remove terminal attaching hardware on individual components to remove terminal lug connections.NOTETerminal hardware is supplied with most components and cannot be purchased separately.Retain all hardware if original component is not being replaced. If component is being replaced,use new hardware supplied.(c)Reinstall terminal attaching hardware back on components to prevent loss.b.Testing.(1)Cut tie down electrical wraps (Figure 4-28, 1) and (2).4-88
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
