TM 9-4310-397-14
6-5. FLYWHEEL AND HOUSING INSPECTION. REPAIR, AND REPLACEMENT. - Continued
(2)
Install flywheel.
WARNING
Flywheel is heavy. Plan proper handling procedures to avoid injuries.
(a)
Install two guide studs (Figure 6-18, 2) if required, in crankshaft cap screw threaded holes. Place flywheel
(4) on studs and slide into position against crankshaft.
CAUTION
Always install new flywheel cap screws when flywheel has been removed.
(b)
Start new cap screws (1) (item 52, appendix H) in crankshaft (5). Do not tighten until guide studs (2) if
installed, are removed and all cap screws started.
(c)
Torque screws (1) 120 ft-lb (160 Nm).
(d)
Install oil pan per paragraph 6-7.
(e)
Install engine in air compressor per paragraph 4-72.
6-20
