TM 9-4310-397-14
6-5. FLYWHEEL AND HOUSING INSPECTION. REPAIR, AND REPLACEMENT.
This task covers:
a.
Inspection
b.
Removal
c.
Repair
d.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
Automotive Maintenance and Repair
Engine removed. (See para 4-72.)
Item 2, Section III, Appendix B
Oil pan removed. (See para 6-7.)
Personnel Required:
Two
a.
Inspection. Check fly-wheel and housing for cracks or other damage. Replace if damaged.
b.
Removal.
(1)
Flywheel.
NOTE
Flywheel can be secured at TDC by inserting a 5/16 inch diameter (8 mm) bolt or rod into an
existing hole in the flywheel housing.
(a) Remove two of the four cap screws (Figure 6-18, 1).
Figure 6-18. Flywheel
(b) Install guide studs (2) in their place if required.
6-18