TM 5-4220-233-14
b.
Installation.
(1) Secure new fusible link (5) to panel (8) with two screws (9), nuts (10), and washers (11).
(2) Secure panel (8) to electrical box (1) with four screws (7).
(3) Connect terminal block wire to new fusible link.
(4) Connect wires of intervehicular cable (4) to five fusible links (5) and terminal board (6) as shown on
electrical schematic placard (Also shown in Figure 4-42).
(5) Spray a coat of electrical varnish (Item 18, Appendix D) on connections between (cable, five fusible links
(5), and terminal board (6).
(6) Close lid on electrical box (1) and secure by sliding four clips (3) over edge of lid and tightening four screws
(2).
4-88