TM 5-4220-233-14
4-53. FUSIBLE LINKS.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP :
Tools
Materials/Parts Appendix D
Screwdriver, Cross Tip
Varnish, Electrical (item 18)
Screwdriver, Flat Tip
Wrench, 3/8"
Equipment Conditions
Wrench, 1/4"
None
a.
Removal.
WARNING
SHOCK HAZARD. Prior to working on electrical system ensure
intervehicular cable is not connected. Failure to follow this warning may
result in serious injury.
Figure 4-45. Replace fusible links.
(1) Open lid on electrical box (1) by loosening four screws (2) and sliding clips (3) off edge of lid.
(2) Disconnect wires on intervehicular cable (4) from five fusible links (5) and terminal board (6).
(3) Disconnect terminal board wire from faulty fusible link.
(4) Remove four screws (7) securing electrical panel (8) to electrical box (1).
(5) Lift up on electrical panel (8) to gain access to fusible link mounting screws (9).
(6) Remove two screws (9), attaching nuts (10), and washers (11). Then, detach fusible link from panel.
4-87
