(10) Install a new gasket (17) on the hous-
Install the washer (13), spring (14),
ing cover (19 ) and secure with six
and sleeve (15) in the spindle.
machine screws (20).
Install a bumper spring (22) in each
(11) Install the breather (18) in the hous-
weight (21). Install the weights on
ing cover.
the spindle, and install the pins (9)
(12) Install the tube assemblies (par. 87).
and lockwires (8) in the weights and
spindle.
Install the sleeve (6) in the cover
LP-5 t 2-ENG)
(19).
a. Removal. Remove the pipe nipple from
Install the gasket (5) on the body (4)
the unloader valve (5, fig. 2).
and install the body in the cover.
b. Cleaning, Inspection, Repair.
Insert the ball (3) and spring (2) in-
(1) Clean all parts with an approved
to the body (4).
cleaning solvent and dry thoroughly.
Install the release valve cap (1) on
(2) Inspect all parts for cracks, breaks,
the body. Tighten the cap securely
and worn surfaces,
to prevent any leakage of air.
(3) Replace any defective parts.
c. Installation. Install the pipe nipple in the
Install the plunger (16) in the sleeve
unloader valve (5, fig. 2).
(6).
