Section IX. PNEUMATIC EQUIPMENT

TM 5-4310-275-14

(1) Refer to Figure 4-3 and install the axle

(2) Install the wheel assemblies.

assembly in reverse sequence of removal.

Section IX. PNEUMATIC EQUIPMENT

4-26. General

(1) The air discharge hose assembly is not

connected to the compressor assembly unless in

The pneumatic equipment includes the air

use.

compressor, air receiver, separator and filter

(2) Unwrap the air discharge hose assembly

assembly, dehydrator assembly, line filter

from the storage brackets attached to the top of

assembly, gages, valves, connecting lines, and

the compressor enclosure (fig. 1-3).

the air discharge hose assembly.

b. Disassembly. Refer to Figure 4-4 and

4-27. Air Discharge Hose Assembly Re-

disassemble the air discharge hose assembly in

placement

the same sequence as shown.

a. Removal.

Figure 4-4. Air discharge hose assembly, disassembly and reassembly.

c. Cleaning and Inspection.

d. Assembly. Refer to Figure 4-4 and assemble

(1) Clean the hose assembly and parts with

the air discharge hose in reverse sequence of

ethyl alcohol, Federal Specification O-E-760.

disassembly.

Allow to air dry thoroughly.

e. Installation. Wrap the air discharge hose

assembly around the storage brackets and secure

(2) Inspect for frayed or worn hose.

with the retainer (fig. 1-3).

(3) Inspect for damaged threads.

(4) Replace any part that is defective.