TM 5-4310-276-14
Table 4-2. Troubleshooting (cont)
Malfunction
Test or Inspection
Corrective Action
(a) Remove the front throttle housing cover and gasket.
(b) Open clevis and disconnect from the throttle lever.
(c) Hold the throttle 1/16 inch from the open position.
(d) Loosen the locknut below the clevis and scre the clevis up or down until the clevis
pin aligns with the hole in the throttle lever.
(e) Connect the clevis to the throttle lever and tighten locknut.
(f) Imtall the gasket and front throttle housing cover.
(g) To regulate engine speed, turn nut on control rod assembly clockwise to increase or
counterclockwise to decrease engine speed.
4-21
