TM 5-4310-276-14
Table 4-2. Troubleshooting (cont)
Malfunction
Test or Inspection
Corrective Action
(a) Remove screws and remove front throttle housing cover and gasket.
(b) Loosen setscrew and release governor control rod. Push throttle level down as far
as possible. Hold governor control rod in downward position, and move throttle level up
about 1/16 inch.
(c) Tighten setscrew and inspect linkage for free play by manually operating carbu-
retor throttle shaft.
(d) To regulate speed of engine, loosen nut and turn control rod assembly clockwise to
increase, or counterclockwise to decrease engine speed.
(e) Install front throttle housing gasket and front throttle housing.
NOTE
Eliminate surging or poor speed regulation by adjusting the main adjustment needle on the carburetor.
(2) Model 1A08-3 (use figure 4-14 as a guide).
4-20
