TM 5-4310-354-14
REMOVAL
STEP 1.
DISCONNECT
OVERSPEED
LEADS
FROM
OVERSPEED
SWITCH
TERMINALS.
DISCONNECT WIRING HARNESS LEADS
FROM SWITCH TERMINALS.
STEP 2.
REMOVE
THE
LOCKNUTS,
CAP
SCREWS, AND RUBBER WASHERS
THAT SECURE SWITCH TO END PANEL
AND
REMOVE
THE
OVERSPEED
SWITCH.
INSTALLATION
STEP 1.
INSTALL THE OVERSPEED SWITCH ON
END PANEL WITH GROUND WIRE
ATTACHED TO ONE MOUNTING SCREW.
ATTACH SWITCH WITH CAP SCREWS,
RUBBER WASHERS BETWEEN SWITCH
AND END PANEL, AND LOCKNUTS.
STEP 2.
CONNECT WIRING HARNESS LEADS
TS 5-4310-354-14/4-14
AND OVERSPEED TRANSMITTER LEADS
TO SWITCH TERMINALS. REFER TO FIG
Figure 4-14. Engine overspeed shutdown switch, removal and installation.
4-32
