TM 5-4310-354-14
A OIL SEPARATOR ASSEMBLY
REMOVAL
TS5-4310-354-14/4-22
NOTE
TAG EACH HOSE ASSEMBLY AS IT
B COMPRESSOR AIR CONTROL
IS
REMOVED
TO
AID
IN
INSTALLATION
INSTALLATION.
STEP 1.
IF REMOVED, INSTALL ELBOW IN
STEP 1.
DISCONNECT
THE
TWO
HOSE
INTAKE CONTROL BODY AND INSTALL
ASSEMBLIES FROM ELBOWS ON OIL
HOSE ASSEMBLY ON ELBOW AND
SEPARATOR COVER. WORK THE SPLIT
CONNECTOR ON STATOR DRIVE END
GROMMETS OUT OF END PANEL
COVER (SEE FIG. 5-1 FOR SCHEMATIC
HOLES. DISCONNECT THE OTHER END
DIAGRAM).
OF THESE TWO HOSE ASSEMBLIES
FROM BLOWDOWN ASSEMBLY.
STEP 2.
INSTALL HOSE ASSEMBLY FROM AIR
PRESSURE GAUGE ON INSTRUMENT
STEP 2.
DISCONNECT AND REMOVE HOSE
PANEL TO BLOWDOWN ASSEMBLY.
ASSEMBLY FROM FLOW SIGHT GAUGE
ELBOW AND ELBOW ON COMPRESSOR
STEP 3.
IF REMOVED, INSTALL ELBOW IN
INTAKE
CONTROL
BODY.
AS
INTAKE CONTROL COVER.
INSTALL
NECESSARY, REMOVE ELBOW FROM
HOSE ASSEMBLY ON COVER ELBOW
BODY.
AND
ELBOW
ON
PRESSURE
REGULATOR.
STEP 3.
DISCONNECT AND REMOVE HOSE
ASSEMBLY FROM ELBOW ON AIR
STEP 4.
IF REMOVED, INSTALL ELBOW IN
PRESSURE REGULATOR AND ELBOW
INTAKE CONTROL BODY.
INSTALL
ON COMPRESSOR INTAKE CONTROL
HOSE ASSEMBLY ON BODY ELBOW AND
COVER.
AS NECESSARY, REMOVE
ELBOW ON FLOW SIGHT GAUGE.
ELBOW FROM COVER.
STEP 5.
INSTALL THE TWO HOSE ASSEMBLIES
STEP 4.
DISCONNECT AND REMOVE HOSE
FROM BLOWDOWN ASSEMBLY TO OIL
ASSEMBLY
FROM
BLOWDOWN
SEPARATOR COVER BY CONNECTING
ASSEMBLY AND AIR PRESSURE GAUGE
HOSES TO BLOWDOWN ASSEMBLY,
ON INSTRUMENT PANEL ASSEMBLY.
INSTALL SPLIT GROMMETS ON HOSE,
RUN HOSES THROUGH HOLES IN END
STEP 5.
AS
NECESSARY,
REMOVE
HOSE
PANEL, CONNECT HOSES TO ELBOWS
ASSEMBLY
FROM
ELBOW
ON
ON OIL SEPARATOR COVER; THEN,
COMPRESSOR INTAKE CONTROL BODY
WORK GROMMETS INTO END PANEL
AND CONNECTOR ON STATOR DRIVE
HOLES.
END COVER. AS NECESSARY, REMOVE
ELBOW FROM INTAKE CONTROL BODY.
Figure 4-22. Compressor control air hoses and fittings, removal and installation.
4-45
