TM 5-4310-354-14
TS5-4310-354-14/4-25
REMOVAL
INSTALLATION
STEP 1.
DISCONNECT
THE
STEP 1.
INSTALL THE ALTERNATOR ASSEMBLY
GROUND WIRE AND WIRING HARNESS
IN POSITION ON PIVOT AND MOUNTING
LEADS.
BRACKET. INSTALL CAP SCREW, LOCK
WASHER, AND NUT. DO NOT TIGHTEN
STEP 2.
LOOSEN PIVOT NUT, ADJUSTING ARM
PIVOT NUT UNTIL AFTER BELT IS
CAP SCREWS, AND MOVE ALTERNATOR
ADJUSTED.
ASSEMBLY
TOWARD
ENGINE
TO
LOOSEN DRIVE BELT. REMOVE DRIVE
STEP 2.
INSTALL
ADJUSTING
ARM,
FLAT
BELT FROM ALTERNATOR PULLEY.
WASHER, LOCK WASHER, AND CAP
SCREW. DO NOT TIGHTEN. INSTALL
STEP 3.
REMOVE ADJUSTING ARM CAP SCREW,
SPACER BETWEEN ADJUSTING ARM
LOCK WASHER, AND SPACER. REMOVE
AND WATER PUMP AND INSTALL LOCK
CAP SCREW, LOCK WASHER, FLAT
WASHER AND CAP SCREW. DO NOT
WASHER, AND ADJUSTING ARM.
TIGHTEN.
STEP 4.
REMOVE NUT, LOCK WASHER, AND CAP
STEP 3.
INSTALL DRIVE B LT ON ALTERNATOR
E
SCREW FROM ALTERNATOR MOUNTING
PULLEY; THEN, ADJUST DRIVE BELT
AND PIVOT BRACKET. REMOVE THE
TIGHTEN PIVOT NUT AND
ALTERNATOR ASSEMBLY.
ADJUSTING ARM CAP SCREWS.
Figure 4-25. Alternator assembly removal and installation.
4-50
