TM 5-4310-354-14
TS5-4310-354-14/4-23
REMOVAL AND DISASSEMBLY
REASSEMBLY AND INSTALLATION.
STEP 1.
DISCONNECT FUEL LINE FROM FUEL
STEP 1.
IF REMOVED, ASSEMBLE MOUNTING
TRANSFER PUMP AND INLET ELBOW ON
BASE STUD into BASE.
TIGHTEN
TOP OF MOUNTING BASE.
AS
SECURELY.
NECESSARY, REMOVE ELBOWS FROM
STEP 2.
AS NECESSARY, ASSEMBLE FUEL
TRANSFER PUMP AND MOUNTING
FILTER MOUNTING BASE TO ENGINE
BASE.
BRACKET WITH CAP SCREWS, FLAT
STEP 2.
DISCONNECT
FUEL
LINE
FROM
WASHERS, LOCK WASHERS, AND NUTS.
MOUNTING BASE OUTLET ELBOW AND
STEP 3.
INSTALL A NEW SPIN-ON TYPE FUEL
FROM FUEL INJECTION PUMP INLET. AS
FILTER ELEMENT AND TIGHTEN WITH A
NECESSARY, REMOVE ELBOW FROM
STRAP-TYPE WRENCH.
MOUNTING BASE.
STEP 4.
AS NECESSARY, INSTALL INLET AND
STEP 3.
REMOVE THE FUEL LINE CLAMPS AND
OUTLET ELBOWS IN MOUNTING BASE.
FUEL LINES FROM UNIT.
CONNECT FUEL LINE TO OUTLET
STEP 4.
USE A STRAP-TYPE WRENCH AND
ELBOW AND FUEL INJECTION PUMP
UNSCREW THE SPIN-ON TYPE FILTER
INLET.
ELEMENT. DISCARD ELEMENT.
STEP 5.
AS NECESSARY, INSTALL ELBOW IN
STEP 5.
AS NECESSARY, REMOVE THE NUTS,
FUEL
TRANSFER
PUMP
OUTLET.
LOCK WASHERS, FLAT WASHER, CAP
CONNECT FUEL LINE TO TRANSFER
SCREWS, AND FUEL FILTER MOUNTING
PUMP OUTLET ELBOW AND FILTER
BASE FROM ENGINE BRACKET.
INLET ELBOW.
STEP 6.
THE MOUNTING BASE STUD NEED BE
STEP 6.
SECURE THE FUEL LINES WITH HOSE
REMOVED FROM BASE ONLY WHEN
REPLACEMENT IS NECESSARY.
Figure 4-23. Engine fuel filter group, removal, disassembly, reassembly, and installation.
4-47