TM 5-4310-368-14
NOTE
Door must be centered in enclosure opening.
(4)
Position screw through end of each check cable. Install and secure bolt and nut in proper hole in
enclosure.
(5)
Open and close door to ensure proper operation. Adjust as required.
4-18.
TOOL BOX
This task covers:
a.
Removal
b.
Repair
c.
Installation
INITIAL SETUP
Applicable Configurations
All
a.
Removal
(1)
Remove four screws and four nuts.
(2)
Remove tool box and lid from enclosure.
(3)
Remove two bolts and two nuts from tool box lid.
(4)
Remove tool box lid from tool box.
b.
Repair
(1)
Repair tool box and lid as required.
(2)
Paint tool box and lid with proper paint.
c.
Installation
(1)
Position tool box lid to tool box.
(2)
Align bolt holes in tool box lid hinge with bolt holes in tool box.
(3)
Install and secure two screws and nuts.
(4)
Position tool box and lid into enclosure.
4-17
