TM 5-4310-368-14
a.
Testinq
(1)
Start engine. Refer to operating instructions.
(2)
Observe ammeter. Ammeter pointer should be on the charge side of "0." If not, use multimeter to check
voltage between one ammeter post and ground. Voltage should be 12.5 - 14.5 VDC. If voltage is below
this value, replace alternator.
b.
Removal
(1)
Remove adjusting bolt and washers.
(2)
Remove nut and lock washer from pivot bolt. Do not remove pivot bolt.
(3)
Remove drive belt.
(4)
Disconnect wire harness at two places.
(5)
Remove pivot bolt and alternator.
c.
Repair. Refer to direct support maintenance.
d.
Installation
(1)
Align alternator pivot bolt hole with bolt hole in alternator support plate.
(2)
Install pivot bolt through alternator and alternator support plate.
(3)
Loose assemble lock washer and nut onto pivot bolt.
(4)
Connect wire harness to alternator at two places.
(5)
Install drive belt.
(6)
Loose assemble adjusting bolt and lock washer to alternator adjusting link and alternator.
(7)
Pull down on alternator to obtain correct drive belt tension. Secure adjusting link bolt and lock washer.
(8)
Secure pivot bolt, lock washer and nut.
4-23.
STARTER ASSEMBLY
This task covers:
a.
Testing
c.
Repair and Overhaul
b.
Removal
d.
Installation
4-21
