TM 5-4310-368-14
b.
Removal
(1)
Disconnect starter cable at the starter.
(2)
Remove two nuts and lock washers.
(3)
Remove starter support bracket.
(4)
Remove three bolts and lock washers. Remove the starter.
c.
Repair and Overhaul. Refer to direct support and general support maintenance.
d.
Installation
(1)
Position starter into opening in engine shroud.
(2)
Align bolt holes in starter flange with bolt holes in engine shroud.
(3)
Install three bolts and lock washers into starter and engine shroud.
(4)
Position starter support bracket over mounting studs and end of starter.
(5)
Install and secure two nuts and lock washers.
(6)
Connect and secure starter cable at starter.
4-24.
ENGINE ASSEMBLY, OPERATIONAL TEST
This task covers:
a. Testing
INITIAL SETUP
Applicable Configurations
All
a.
Testing
(1)
Start engine and compressor, using normal operating instructions.
(2)
Allow compressor to run 10-15 minutes.
(3)
While operating at full load and about 3300 - 3500 PSI receiver pressure, check compressor speed and
engine speed with tachometer.
(4)
Adjust engine speed as required. Refer to direct support maintenance.
4-23
