TM 5-4310-368-14
(6)
Inspect rotor shaft. Replace bent, scored or warped rotor.
(7)
Inspect alternator housing for breaks, cracks or other damage. Replace defective housing.
d. Reassembly
(1)
Install front and rear bearings onto rotor shaft.
(2)
Position rotor assembly into front housing.
(3)
Seat bearing into front housing. Secure with snap ring.
(4)
Position spacer, fan, pulley, lock washer and pulley nut over the end of the rotor shaft. Secure the nut to
35-50 Ib-ft torque.
(5)
Install stator into front housing.
(6)
Position rear housing over end of rotor assembly. Align rear housing bolt holes with bolt holes in front
housing. Install and secure four bolts and four nuts.
(7)
Position brush holder into opening in rear housing. Align brush holder with two pins in rear housing.
Secure brush holder with two screws.
(8)
Position voltage regulator over rear of alternator assembly. Connect lead from brush holder to voltage
regulator. Secure voltage regulator to alternator with two screws.
(9)
Install nylon sleeve over lower negative stud on rear of alternator housing. Position isolation diode over
studs on rear of alternator housing.
(10)
Install fibre washer over same stud as nylon sleeve. Secure isolation diode with two nuts.
5-9.
This task covers:
a. Disassembly
b. Cleaning
c.
Inspection
INITIAL SETUP
Applicable Configurations
All
Equipment Condition
Paragraph
Condition Description
Starter Removed
5-15
