TM 5-4310-377-13
3-11.
MOTOR STARTER BOX - Continued.
Figure 3-5. Starter Box, Assembly.
(1) Install coil (1), spring (2), and cover (3). Secure with two spring clips (4).
(2) Install contactor (5) and secure with two screws (6).
(3) Install overload (7) by pushing straight up and secure by tightening screws T1, T2, and T3 (8).
(4) Connect the wiring to the overload (7) and to the contactor (5)
per the tagged identification.
(5) Install the rear of the switch and the RESET switch (9) and then turn the switch one-quarter turn clockwise.
Secure by tightening two screws (10).
(6) Install the rear of the switch and the on/off switch (11) and then turn the switch one-quarter turn clockwise.
Secure by tightening the two screws (12).
(7) Connect the wiring to the switch (11) per the tagged identification.
GO TO NEXT PAGE
3-21
